Car Stereo System - Car Radio Digital Signal Processor User Manual

www.ti.com
TXC (at DSP)
(B)
TXD[3:0]
(A)
TXCTL
(A)
5
6
1st Half-byte
TXERRTXEN
2nd Half-byte
1
2
Internal TXC
TXC at DSP pins
4
4
2
3
1
SM320C6455-EP
FIXED-POINT DIGITAL SIGNAL PROCESSOR
SPRS462B – SEPTEMBER 2007 – REVISED JANUARY 2008
Table 7-88. Switching Characteristics Over Recommended Operating Conditions for EMAC RGMII
Transmit
(1)
(see Figure 7-70 )
-720
-850
A-1000/-1000
NO. PARAMETER UNIT
-1200
MIN MAX
5 t
su(TXD-TXCH)
Setup time, transmit selected signals valid before TXC (at DSP) high/low 1.2 ns
6 t
h(TXCH-TXD)
Hold time, transmit selected signals valid after TXC (at DSP) high/low 1.2
(1) For RGMII, transmit selected signals include: TXD[3:0] and TXCTL.
A. Data and control information is transmitted using both edges of the clocks. TXD[3:0] carries data bits 3-0 on the rising
edge of TXC and data bits 7-4 on the falling edge of TXC. Similarly, TX_CTL carries TXEN on rising edge of TXC and
TXERR of falling edge.
B. TXC is delayed internally before being driven to the TXC pin.
Figure 7-70. EMAC Transmit Interface Timing [RGMII Operation]
(A)(B)
Submit Documentation Feedback C64x+ Peripheral Information and Electrical Specifications 215