Datasheet

SBOA102A
January 2005
Sensor-Emulator-EVM
System Reference Guide
25
Set the jumper
JUMP1 to the
position shown to
connect the Diode
temperature
emulation.
Set the jumper
JUMP5 to the
position shown
to connect GND
to the bottom of
the bridge
emulator.
These jumpers
must be set to the
position shown to
allow the on board
voltage reference
to generate the
emulated diode
voltages.
These three
channels are used
to set the
temperature output
signal in this mode.
The Rtchannels
are not used in this
mode.