Reference Guide

27
May ’01 Chapter 4. Technical Data
4.1 Specification Summary
* If the configured output power is above 4 W, an additional 0.8 K/W heat sink is
necessary
Table 19: Ambient Conditions
Operating Temperature
-20°C to +65°C
Storage Temperature
-40°C to +85°C
Vibration
According to EN60068-2-6, 10 Hz to 200 Hz: 0.15 mm / 2 g
Shock
According to EN60068-2-27, acceleration 30 g
Table 20: Electrical Data
Supply Voltage
24 VDC +5%/-1%
Ripple: maximum 20 mV
Power Consumption
maximum 60 W
Operating Frequency
13.56 MHz ± 7 kHz
Transmitter Power
0.5 to 10 W*
(set by software in steps of 0.25W)
Transmitter Modulation
(10% to 30%) ± 6% and 100% (adjustable by software)
Antenna Connection
- Tx/Rx Antenna
- Rx Only Antenna
1 x SMA socket (50W)
1 x SMA socket (50W)
Optocoupler Outputs
24 V DC / 30 mA (galvanically isolated)
Relay (1 x change-over)
Outputs
24 V DC / 60 W
Optocoupler Inputs
maximum 24 V DC/ 20 mA
Interfaces
RS232 and RS485 (internally selectable)
Memory
EEPROM 1 kByte (for parameters; up to 10,000 write
cycles)
RAM 256 kByte (for data)
Flash 512 kByte (for firmware; update via
communication interface)