Datasheet

REG102
2
SBVS024F
www.ti.com
PIN CONFIGURATIONS
Top View
V
OUT
(2)
V
OUT
(2)
NR/Adjust
(1)
GND
V
IN
(3)
V
IN
(3)
NC
Enable
SO-8
1
2
3
4
8
7
6
5
NOTES: (1) For REG102A-A: voltage setting resistor pin.
All other models: noise reduction capacitor pin.
(2) Both pin 1 and pin 2 must be connected.
(3) Both pin 7 and pin 8 must be connected.
SOT223-5
(U Package)
V
IN
GND
Enable
V
OUT
NR/Adjust
(1)
SOT23-5
1
2
3
5
4
(N Package)
(G Package)
Tab is GND
Enable
NR/Adjust
(1)
GNDV
IN
12345
V
OUT
ABSOLUTE MAXIMUM RATINGS
(1)
Supply Input Voltage, V
IN
.......................................................–0.3V to 12V
Enable Input Voltage, V
EN
....................................................... –0.3V to V
IN
Feedback Voltage, V
FB
........................................................ –0.3V to 6.0V
NR Pin Voltage, V
NR
.............................................................–0.3V to 6.0V
Output Short-Circuit Duration ...................................................... Indefinite
Operating Temperature Range (T
J
) ................................ –55°C to +125°C
Storage Temperature Range (T
A
) ................................... –65°C to +150°C
Lead Temperature (soldering, 3s).................................................. +240°C
NOTE: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may degrade
device reliability.
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Texas
Instruments recommends that all integrated circuits be handled
with appropriate precautions. Failure to observe proper han-
dling and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.
PACKAGE/ORDERING INFORMATION
(1)
PRODUCT V
OUT
(2)
REG102xx- yyyy/zzz XX is package designator.
YYYY is typical output voltage (5 = 5.0V, 2.85 = 2.85V, A = Adjustable).
ZZZ is package quantity.
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI website at www.ti.com.
(2) Output voltages from 2.5V to 5.1V in 50mV increments are available; minimum order quantities apply. Contact factory for details and availability.