Datasheet

LAYER A MASTER
SLAVE
1
1
LAYER B MASTER
SLAVE
1 1
UDG-07107
AGND
PTH08T250W
SLTS278G –NOVEMBER 2010–REVISED MARCH 2009 www.ti.com
Current Sharing Layout
In current sharing applications the V
I
pins of both modules must be connected to the same input bus. The V
O
pins of both modules are connected together to power the load. The GND pins of both modules are connected
via the GND plane. Four other inter-connection pins are connected between the modules. Figure 33 shows the
required layout of the inter-connection pins for two modules configured to share current. Notice that the Share
(pin 2) connection is routed between the Comp (pin 3) and CLKIO (pin 5) connections. AGND (pin 4) should be
connected as a thicker trace on an adjacent layer, running parallel to pins 2, 3 and 5. AGND must not be
connected to the GND plane.
Figure 33. Recommended Layout of Inter-Connection Pins Between Two Current Sharing Modules
Prebias Startup Capability
A prebias startup condition occurs as a result of an external voltage being present at the output of a power
module prior to its output becoming active. This often occurs in complex digital systems when current from
another power source is backfed through a dual-supply logic component, such as an FPGA or ASIC. Another
path might be via clamp diodes as part of a dual-supply power-up sequencing arrangement. A prebias can cause
problems with power modules that incorporate synchronous rectifiers. This is because under most operating
conditions, these types of modules can sink as well as source output current.
The PTH family of power modules incorporate synchronous rectifiers, but does not sink current during startup
(1)
,
or whenever the Inhibit pin is held low. However, to ensure satisfactory operation of this function, certain
conditions must be maintained
(2)
. Figure 35 shows an application demonstrating the prebias startup capability.
The startup waveforms are shown in Figure 34. Note that the output current (I
O
) is negligible until the output
voltage rises above the voltage backfed through the intrinsic diodes.
30 Submit Documentation Feedback Copyright © 2010–2009, Texas Instruments Incorporated
Product Folder Link(s): PTH08T250W