Datasheet

SLDU010
TI CONFIDENTIAL – NDA Restrictions
Page 25 of 50
6.6.2 Program OTP Memory from .HEX File
If the “Program OTP Memory from .HEX File” check box was checked (default) when the .HEX
file was loaded into the GUI, the OTP memory will be programmed with the contents of the .HEX
file.
6.6.3 Verify OTP Programming
If the “Verify OTP Programming” button was also checked (default) then after the OTP memory
is finished programming, the GUI will reset the MCU and then verify that the contents of the OTP
memory match the .HEX file. If the OTP memory matches the contents of the .HEX file, the GUI
will display the message “OTP Memory Verification Successful” as seen in the figure below.
Figure 18. OTP Memory Successful Programming
Verification
7 Controlling the PGA400-Q1 Functions with the GUI
The previous section focuses on the left side of the GUI which is primarily setup for direct
register manipulation. The right side of the GUI is focused much more on providing a graphical
method for controlling the PGA400-Q1.