Datasheet
SLES105B − FEBRUARY 2004 − REVISED NOVEMBER 2006
www.ti.com
32
OS[1:0]: Delta-Sigma Oversampling Rate Selection
These bits are available for read and write.
Default value: 00
OS[1:0] Operation Speed Select
00 64 times f
S
(default)
01 32 times f
S
10 128 times f
S
11 Reserved
The OS bits are used to change the oversampling rate of delta-sigma modulation. Use of this function enables the designer
to stabilize the conditions at the post low-pass filter for different sampling rates. As an application example, programming
to set 128 times in 44.1-kHz operation, 64 times in 96-kHz operation, and 32 times in 192-kHz operation allows the use
of only a single type (cutoff frequency) of post low-pass filter. The 128 f
S
oversampling rate is not available at sampling rates
above 100 kHz. If the 128-f
S
oversampling rate is selected, a system clock of more than 256 f
S
is required.
In DSD mode, these bits are used to select the speed of the bit clock for DSD data coming into the analog FIR filter.
B15 B14 B13 B12 B11 B10 B9 B8 B7 B6 B5 B4 B3 B2 B1 B0
Register 21 R/W 0 0 1 0 1 0 1 RSV RSV RSV RSV RSV DZ1 DZ0 PCMZ
R/W: Read/Write Mode Select
When R/W = 0, a write operation is performed.
When R/W = 1, a read operation is performed.
Default value: 0
DZ[1:0]: DSD Zero Output Enable
These bits are available for read and write.
Default value: 00
DZ[1:0] Zero Output Enable
00 Disabled (default)
01 Even pattern detect
1x 96
H
pattern detect
The DZ bits are used to enable or disable the output zero flags, and to select the zero pattern in the DSD mode.
PCMZ: PCM Zero Output Enable
These bits are available for read and write.
Default value: 1
PCMZ = 0 PCM zero output disabled
PCMZ = 1 PCM zero output enabled (default)
The PCMZ bit is used to enable or disable the output zero flags in the PCM mode and the external DF mode.
B15 B14 B13 B12 B11 B10 B9 B8 B7 B6 B5 B4 B3 B2 B1 B0
Register 22 R 0 0 1 0 1 1 0 RSV RSV RSV RSV RSV RSV ZFGR ZFGL
R: Read Mode Select
Value is always 1, specifying the readback mode.