Datasheet


SLES105B − FEBRUARY 2004 − REVISED NOVEMBER 2006
www.ti.com
15
SYSTEM CLOCK AND RESET FUNCTIONS
System Clock Input
The PCM1792A requires a system clock for operating the digital interpolation filters and advanced segment DAC
modulators. The system clock is applied at the SCK input (pin 7). The PCM1792A has a system clock detection circuit that
automatically senses if the system clock is operating between 128 f
S
and 768 f
S
. Table 1 shows examples of system clock
frequencies for common audio sampling rates. If the oversampling rate of the delta-sigma modulator is selected as 128 f
S
,
the system clock frequency is over 256 f
S
.
Figure 24 shows the timing requirements for the system clock input. For optimal performance, it is important to use a clock
source with low phase jitter and noise. One of the Texas Instruments’ PLL1700 family of multiclock generators is an
excellent choice for providing the PCM1792A system clock.
Table 1. System Clock Rates for Common Audio Sampling Frequencies
SAMPLING FREQUENCY
SYSTEM CLOCK FREQUENCY (f
SCK
) (MHz)
SAMPLING FREQUENCY
128 f
S
192 f
S
256 f
S
384 f
S
512 f
S
768 f
S
32 kHz 4.096
(1)
6.144
(1)
8.192 12.288 16.384 24.576
44.1 kHz 5.6488
(1)
8.4672 11.2896 16.9344 22.5792 33.8688
48 kHz 6.144
(1)
9.216 12.288 18.432 24.576 36.864
96 kHz 12.288 18.432 24.576 36.864 49.152
(1)
73.728
(1)
192 kHz 24.576 36.864 49.152
(1)
73.728
(1) (2) (2)
(1)
This system clock rate is not supported in I
2
C fast mode.
(2)
This system clock rate is not supported for the given sampling frequency.
t
(SCKH)
t
(SCY)
System Clock (SCK)
t
(SCKL)
2 V
0.8 V
H
L
PARAMETERS MIN MAX UNITS
t
(SCY)
System clock pulse cycle time 13 ns
t
(SCKH)
System clock pulse duration, HIGH 0.4 t
(SCY)
ns
t
(SCKL)
System clock pulse duration, LOW 0.4 t
(SCY)
ns
Figure 24. System Clock Input Timing
Power-On and External Reset Functions
The PCM1792A includes a power-on reset function. Figure 25 shows the operation of this function. With V
DD
> 2 V, the
power-on reset function is enabled. The initialization sequence requires 1024 system clocks from the time V
DD
> 2 V. After
the initialization period, the PCM1792A is set to its default reset state, as described in the MODE CONTROL REGISTERS
section of this data sheet.
The PCM1792A also includes an external reset capability using the RST input (pin 14). This allows an external controller
or master reset circuit to force the PCM1792A to initialize to its default reset state.
Figure 26 shows the external reset operation and timing. The RST pin is set to logic 0 for a minimum of 20 ns. The RST
pin is then set to a logic 1 state, thus starting the initialization sequence, which requires 1024 system clock periods. The
external reset is especially useful in applications where there is a delay between the PCM1792A power up and system clock
activation.