Datasheet

www.ti.com
PCM1772 , PCM1773
SLES010G – SEPTEMBER 2001 – REVISED MARCH 2007
Register 03
B15 B14 B13 B12 B11 B10 B9 B8 B7 B6 B5 B4 B3 B2 B1 B0
0 IDX6 IDX5 IDX4 IDX3 IDX2 IDX1 IDX0 OVER RSV RINV AMIX DEM FMT2 FMT1 FMT0
IDX[6:0]: 000 0011b
OVER: Oversampling Control
Default Value: 0
OVER = 0 128f
S
oversampling
OVER = 1 192f
S
, 256f
S
, 384f
S
oversampling
The OVER bit controls the oversampling rate of the ∆ - Σ D/A converters. When it operates at a low sampling
rate, less than 24 kHz, this function is recommended.
RINV: Polarity Control for Line Output, V
OUT
R
Default Value: 0
RINV = 0 Not inverted
RINV = 1 Inverted output
The RINV bits allow the user to control the polarity of the line output, V
OUT
R. This function can be used to
connect the monaural speaker with BTL connection method. This bit is recommended to be 0 during the
power-up/-down sequence for minimizing audible pop noise.
AMIX: Analog Mixing Control for External Analog Signal, AIN
Default Value: 0
AMIX = 0 Disabled (not mixed)
AMIX = 1 Enabled (mixing to the DAC output)
AMIX bit allows the user to mix analog input (AIN) with line outputs (V
OUT
L/V
OUT
R) internally.
DEM: 44.1-kHz De-Emphasis Control
Default Value: 0
DEM = 0 Disabled
DEM = 1 Enabled
The DEM bit enables or disables the digital de-emphasis filter for 44.1-kHz sampling rate.
FMT[2:0]: Audio Interface Data Format
Default Value: 000
The FMT[2:0] bits select the data format for the serial audio interface. The following table shows the available
format options.
FMT[2:0] Audio Data Format Selection
000 16- to 24-bit, left-justified format (default)
001 16- to 24-bit, I
2
S format
010 24-bit right-justified data
011 20-bit right-justified data
100 16-bit right-justified data
101 16- to 24-bit, left-justified format, master mode
110 Reserved
111 Reserved
25
Submit Documentation Feedback