Datasheet

V
CC
Ramp-Up Re-Ramp-Up
Time to Re-Ramp
Time
Ramp-Down
V
CC_RT
V
CC_RT
V
CC_FT
V
CC_TRR_GND
LED
3.3 V
5 V
LEDx
V
CC
LED
LEDx
V
CC
100 kW
V
CC
PCA9534A
www.ti.com SCPS141H –SEPTEMBER 2006–REVISED AUGUST 2013
Minimizing I
CC
When the I/O Controls LEDs
When the I/Os are used to control LEDs, they normally are connected to V
CC
through a resistor as shown in
Figure 15. Because the LED acts as a diode, when the LED is off, the I/O V
IN
is about 1.2 V less than V
CC
. The
supply current, I
CC
, increases as V
IN
becomes lower than V
CC
and is specified as ΔI
CC
in Electrical
Characteristics.
For battery-powered applications, it is essential that the voltage of the I/O pins is greater than or equal to V
CC
when the LED is off to minimize current consumption. Figure 16 shows a high-value resistor in parallel with the
LED. Figure 17 shows V
CC
less than the LED supply voltage by at least 1.2 V. Both of these methods maintain
the I/O V
IN
at or above V
CC
and prevents additional supply-current consumption when the LED is off.
Figure 16. High-Value Resistor in Parallel With the LED
Figure 17. Device Supplied by a Lower Voltage
Power-On Reset Requirements
In the event of a glitch or data corruption, PCA9534A can be reset to its default conditions by using the power-on
reset feature. Power-on reset requires that the device go through a power cycle to be completely reset. This
reset also happens when the device is powered on for the first time in an application.
The two types of power-on reset are shown in Figure 18 and Figure 19.
Figure 18. V
CC
is Lowered Below 0.2 V or 0 V and Then Ramped Up to V
CC
Copyright © 2006–2013, Texas Instruments Incorporated Submit Documentation Feedback 23
Product Folder Links: PCA9534A