Datasheet

OPA693
6
SBOS285A
www.ti.com
ELECTRICAL CHARACTERISTICS: V
S
= +5V (Cont.)
Boldface limits are tested at +25°C.
G = +2 (–IN grounded though 0.001µF) and R
L
= 100Ω to V
S
/2 (see Figure 4 for AC performance only), unless otherwise noted.
OPA693ID, IDBV
TYP MIN/MAX OVER TEMPERATURE
0 ° C to –40 ° C to MIN/ TEST
PARAMETER CONDITIONS +25°C
(1)
+25°C70°C +85°C UNITS MAX LEVEL
(2 )
DISABLE/POWER DOWN (
DIS
Pin)
Power-Down Supply Current (+V
S
)V
DIS
= 0 –95 –155 –172 –180 µA typ A
Off Isolation G = +2, 5MHz 65 dB typ C
Output Capacitance in Disable 4 pF typ C
Turn-On Glitch G = +2, R
L
= 150Ω, V
IN
= 2.5V ±20 mV typ B
Turn-Off Glitch G = +2, R
L
= 150Ω, V
IN
= 2.5V ±20 mV typ B
Enable Voltage 3.3 3.5 3.6 3.7 V min B
Disable Voltage 1.8 1.7 1.6 1.5 V max B
Control Pin Input Bias Current (
DIS
)V
DIS
= 0 80 137 153 160 µA typ A
POWER SUPPLY
Specified Single-Supply Operating Voltage 5 V typ C
Maximum Single-Supply Operating Voltage +12 +12 +12 V max A
Maximum Quiescent Current V
S
= +5V 11.5 12.0 12.5 12.9 mA max A
Minimum Quiescent Current V
S
= +5V 11.5 11.0 9.5 9.2 mA min A
Power-Supply Rejection Ratio (+PSRR) Input Referred 57 dB typ C
TEMPERATURE RANGE
Specification: D, DBV
–40 to +85 °C typ C
Thermal Resistance, θ
JA
DSO-8 125 °C/W typ C
DBV SOT23-6 150 °C/W typ C
(1) Junction temperature = ambient temperature for low temperature limit and +25°C specifications. Junction temperature = ambient temperature +10°C at high
temperature limit specifications.
(2) Test Levels: (A) 100% tested at +25°C. Over temperature limits by characterization and simulation.
(B) Limits set by characterization and simulation.
(C) Typical value only for information.
(3) Current is considered positive out-of-node. V
CM
is the input common-mode voltage.