Datasheet

OPA693
4
SBOS285A
www.ti.com
ELECTRICAL CHARACTERISTICS: V
S
= ±5V (Cont.)
Boldface limits are tested at 25°C.
G = +2 (–IN grounded) and R
L
= 100Ω (see Figure 1 for AC performance only), unless otherwise noted.
OPA693ID, IDBV
TYP MIN/MAX OVER TEMPERATURE
(1)
0 ° C to –40 ° C to MIN/ TEST
PARAMETER CONDITIONS +25°C +25°C70°C +85°C UNITS MAX LEVEL
(2 )
DISABLE/POWER DOWN (
DIS
Pin)
Power-Down Supply Current (+V
S
)V
DIS
= 0V –70 –170 –186 –192 µAmaxA
Disable Time V
IN
= +1V
DC
3 µs typ C
Enable Time V
IN
= +1V
DC
25 ns typ C
Off Isolation G = +2, 5MHz 70 dB typ C
Output Capacitance in Disable 4 pF typ C
Turn-On Glitch G = +2, R
L
= 150Ω, V
IN
= 0V
DC
±100 mV typ C
Turn-Off Glitch G = +2, R
L
= 150Ω, V
IN
= 0V
DC
±20 mV typ C
Enable Voltage +V
S
= +5V 3.3 3.5 3.6 3.7 V min A
Disable Voltage +V
S
= +5V 1.8 1.7 1.6 1.5 V max A
Control Pin Input Bias Current V
DIS
= 0V 75 130 143 149 µAmaxA
POWER SUPPLY
Specified Operating Voltage ±5 V typ C
Maximum Operating Voltage Range
±6 ±6 ±6VmaxA
Max Quiescent Current V
S
= ±5V 13 13.3 13.7 14.1 mA max A
Min Quiescent Current V
S
= ±5V 13 12.5 11.6 11.0 mA min A
Power-Supply Rejection Ratio (+PSRR) Input Referred 58 54 52 51 dB min A
TEMPERATURE RANGE
Specification: D, DBV
–40 to +85 °C typ C
Thermal Resistance, θ
JA
DSO-8 125 °C/W typ C
DBV SOT23-6 150 °C/W typ C
(1) Junction temperature = ambient temperature for low temperature limit and +25°C specifications. Junction temperature = ambient temperature +20°C at high
temperature limit specifications.
(2) Test Levels: (A) 100% tested at +25°C. Over temperature limits by characterization and simulation.
(B) Limits set by characterization and simulation.
(C) Typical value only for information.
(3) Current is considered positive out-of-node. V
CM
is the input common-mode voltage.