Datasheet

OPA692
6
SBOS236E
www.ti.com
ELECTRICAL CHARACTERISTICS: V
S
= +5V (Cont.)
Boldface limits are tested at +25°C.
G = +2 (–IN grounded though 0.1µF) and R
L
= 100Ω to V
S
/2 (see Figure 2 for AC performance only), unless otherwise noted.
OPA692ID, IDBV
TYP MIN/MAX OVER TEMPERATURE
0 ° C to –40 ° C to MIN/ TEST
PARAMETER CONDITIONS +25°C
(1)
+25°C70°C +85°C UNITS MAX LEVEL
(2 )
DISABLE/POWER DOWN (
DIS
Pin)
Power-Down Supply Current (+V
S
)V
DIS
= 0 –150 –300 –350 –400 µA typ C
Off Isolation G = +2, 5MHz 65 dB typ C
Output Capacitance in Disable 4 pF typ C
Turn-On Glitch G = +2, R
L
= 150Ω, V
IN
= 2.5V ±50 mV typ B
Turn-Off Glitch G = +2, R
L
= 150Ω, V
IN
= 2.5V ±20 mV typ B
Enable Voltage 3.3 3.5 3.6 3.7 V min B
Disable Voltage 1.8 1.7 1.6 1.5 V max B
Control Pin Input Bias Current (
DIS
)V
DIS
= 0 75 130 150 160 µA typ C
POWER SUPPLY
Specified Single-Supply Operating Voltage 5 V typ C
Maximum Single-Supply Operating Voltage 12 12 12 V max A
Maximum Quiescent Current V
S
= +5V 4.5 4.8 5.0 5.2 mA max A
Minimum Quiescent Current V
S
= +5V 4.5 4.1 3.8 3.7 mA min A
Power-Supply Rejection Ratio (+PSRR) Input Referred 55 dB typ C
TEMPERATURE RANGE
Specification: D, DBV
–40 to +85 °C typ C
Thermal Resistance, θ
JA
DSO-8 125 °C/W typ C
DBV SOT23-6 150 °C/W typ C
NOTES: (1) Junction temperature = ambient temperature for low temperature limit and +25°C specifications. Junction temperature = ambient temperature +10°C
at high temperature limit specifications. (2) Test Levels: (A) 100% tested at +25°C. Over-temperature limits by characterization and simulation. (B) Limits set by
characterization and simulation. (C) Typical value only for information. (3) Current is considered positive out-of-node. V
CM
is the input common-mode voltage.