Datasheet

OPA692
4
SBOS236E
www.ti.com
ELECTRICAL CHARACTERISTICS: V
S
= ±5V (Cont.)
Boldface limits are tested at +25°C.
G = +2 (–IN grounded) and R
L
= 100Ω (see Figure 1 for AC performance only), unless otherwise noted.
OPA692ID, IDBV
TYP MIN/MAX OVER TEMPERATURE
0 ° C to –40 ° C to MIN/ TEST
PARAMETER CONDITIONS +25°C +25°C
(1)
70°C +85°C UNITS MAX LEVEL
(2 )
DISABLE/POWER DOWN (
DIS
Pin)
Power-Down Supply Current (+V
S
)V
DIS
= 0 –150 –300 –350 –400 µAmaxA
Disable Time V
IN
= +1V
DC
1 µs typ C
Enable Time V
IN
= +1V
DC
25 ns typ C
Off Isolation G = +2, 5MHz 70 dB typ C
Output Capacitance in Disable 4 pF typ C
Turn-On Glitch G = +2, R
L
= 150Ω±50 mV typ C
Turn-Off Glitch G = +2, R
L
= 150Ω±20 mV typ C
Enable Voltage 3.3 3.5 3.6 3.7 V min A
Disable Voltage 1.8 1.7 1.6 1.5 V max A
Control Pin Input Bias Current V
DIS
= 0 75 130 150 160 µAmaxA
POWER SUPPLY
Specified Operating Voltage ±5 V typ C
Maximum Operating Voltage Range
±6 ±6 ±6VmaxA
Maximum Quiescent Current V
S
= ±5V 5.1 5.3 5.5 5.8 mA max A
Minimum Quiescent Current V
S
= ±5V 5.1 4.9 4.5 4.25 mA min A
Power-Supply Rejection Ratio (–PSRR) Input Referred 58 52 50 49 dB min A
TEMPERATURE RANGE
Specification: D, DBV
–40 to +85 °C typ C
Thermal Resistance,
θ
JA
DSO-8 125 °C/W typ C
DBV SOT23-6 150 °C/W typ C
NOTES: (1) Junction temperature = ambient temperature for low temperature limit and +25°C specifications. Junction temperature = ambient temperature +10°C
at high temperature limit specifications. (2) Test Levels: (A) 100% tested at +25°C. Over-temperature limits by characterization and simulation. (B) Limits set by
characterization and simulation. (C) Typical value only for information. (3) Current is considered positive out-of-node. V
CM
is the input common-mode voltage.