Datasheet

OPA705, 2705, 4705
2
SBOS182A
MINIMUM PACKAGE
RECOMMENDED DRAWING PACKAGE ORDERING TRANSPORT
PRODUCT DESCRIPTION GAIN PACKAGE NUMBER MARKING NUMBER
(1)
MEDIA
OPA705NA Single, GBW = 1MHz 1 SOT23-5 331 A05 OPA705NA/250 Tape and Reel
""""""OPA705NA/3K Tape and Reel
OPA705UA Single, GBW = 1MHz 1 SO-8 182 OPA705UA OPA705UA Rails
""""""OPA705UA/2K5 Tape and Reel
OPA705PA Single, GBW = 1MHz 1 DIP-8 006 OPA705PA OPA705PA Rails
OPA2705EA Dual, GBW = 1MHz 1 MSOP-8 337 B05 OPA2705EA/250 Tape and Reel
""""""OPA2705EA/2K5 Tape and Reel
OPA2705UA Dual, GBW = 1MHz 1 SO-8 182 OPA2705UA OPA2705UA Rails
""""""OPA2705UA/2K5 Tape and Reel
OPA2705PA Dual, GBW = 1MHz 1 DIP-8 006 OPA2705PA OPA2705PA Rails
OPA4705EA Quad, GBW = 1MHz 1 TSSOP-14 357 OPA4705EA OPA4705EA/250 Tape and Reel
""""""OPA4705EA/2K5 Tape and Reel
OPA4705UA Quad, GBW = 1MHz 1 SO-14 235 OPA4705UA OPA4705UA Rails
""""""OPA4705UA/2K5 Tape and Reel
NOTE: (1) Models with a slash (/) are available only in Tape and Reel in the quantities indicated (e.g., /3K indicates 3000 devices per reel). Ordering 3000 pieces
of “OPA705NA/3K” will get a single 3000-piece Tape and Reel.
PACKAGE/ORDERING INFORMATION
Supply Voltage, V+ to V– ................................................................. 13.2V
Signal Input Terminals, Voltage
(2)
.....................(V–) –0.3V to (V+) +0.3V
Current
(2)
.................................................... 10mA
Output Short-Circuit
(3)
.............................................................. Continuous
Operating Temperature ..................................................–55°C to +125°C
Storage Temperature .....................................................–65°C to +150°C
Junction Temperature .................................................................... +150°C
Lead Temperature (soldering, 10s)............................................... +300°C
NOTES: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may
degrade device reliability. (2) Input terminals are diode-clamped to the power
supply rails. Input signals that can swing more than 0.3V beyond the supply
rails should be current-limited to 10mA or less. (3) Short-circuit to ground,
one amplifier per package.
ABSOLUTE MAXIMUM RATINGS
(1)
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Texas Instru-
ments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.