Datasheet
1
2
3
6
5
4
V+
Enable
Out
+In
GND
R
SET
OEA
OPA362
SBOS480 –SEPTEMBER 2009 ........................................................................................................................................................................................
www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
ABSOLUTE MAXIMUM RATINGS
(1)
Over operating free-air temperature range, unless otherwise noted.
VALUE UNIT
Supply Voltage, V+ to V– +3.6 V
Voltage
(2)
– 0.5 to (V+) + 0.5 V
Signal Input
Terminals
Current
(2)
±10 mA
Output Short-Circuit through 75Ω to GND
(3)
Continuous
Operating Temperature –40 to +125 °C
Storage Temperature –65 to +150 °C
Junction Temperature +160 °C
Human Body Model (HBM) 5000 V
ESD Ratings Charged Device Model (CDM) 2000 V
Machine Model (MM) 400 V
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those specified is not supported.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5V beyond the supply rails should
be current-limited to 10mA or less.
(3) Short-circuit to ground.
PACKAGE INFORMATION
(1)
PRODUCT PACKAGE-LEAD PACKAGE DESIGNATOR PACKAGE MARKING
OPA362 SC70-6 DCK OEA
(1) For the most current package and ordering information see the Package Option Addendum at the end of this document, or see the TI
web site at www.ti.com.
DCK PACKAGE
SC70-6
(TOP VIEW)
Note: The location of pin 1 on the OPA362 is determined by orienting the package marking as shown in the illustration.
2 Submit Documentation Feedback Copyright © 2009, Texas Instruments Incorporated
Product Folder Link(s): OPA362