Datasheet

MECHANICAL DATA
MPDS100 – AUGUST 2001
1
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
DTJ (R-PDSO-G8) PLASTIC SMALL–OUTLINE
4202635/A 08/01
–A–
0.1968 (4,98)
0.189 (4,80)
Index
Area
–B–
0.1497 (3,80)
0.1574 (4,00)
0.244 (6,20)
0.2284 (5,80)
0.0532 (1,35)
0.0688 (1,75)
0.016 (0,41)
0.018 (0,46)
0.020 (0,51)
0.013 (0,33)
0.090 (2,29)
0.110 (2,79)
0.130 (3,30)
0.150 (3,81)
0.0098 (0,25)
0.0075 (0,20)
0.0196 (0,50)
0.0099 (0,25)
× 45°
0°–8°
0.050 (1,27)
0.016 (0,41)
Heat Sink
Bottom View
–C–
Plane
Seating
Plane
0.050 (1,27)
Base
0.004 (0,10)
14
58
F
G
D
C
0.001 (0,03)
0.004 (0,10)
B
0.010 (0,25) M
M
X
ø0.015 (0,38)
M
Z
S
A
0.010 (0,25) M
C
M
B
S
NOTES: A. All linear dimensions are in inches (millimeters).
B. This drawing is subject to change without notice.
C. Body length dimension does not include mold flash,
protrusions or gate burrs. Mold flash, protrusions and
gate burrs shall not exceed 0.006 (0,15) per side.
D. Body width dimension does not include inter–lead
flash or protrusions. Inter–lead flash and protrusions
shall not exceed 0.010 (0,25) per side.
E. The chamfer on the body is optional. If it is not
present, a visual index feature must be located within
the cross-hatched area.
F. Lead dimension is the length of terminal for soldering
to a substrate.
G. The lead width, as measured 0.014 (0,36) or
greater above the seating plane, shall not exceed
a maximum value of 0.024 (0,61).
H. Lead-to-lead coplanarity shall be less than
0.004 (0,10) from Seating Plane.
I. Falls within JEDEC MS-012-AA.