Datasheet

"#$%
SBOS249H − JUNE 2003 − REVISED AUGUST 2008
www.ti.com
4
ELECTRICAL CHARACTERISTICS: V
S
= ±6V (continued)
Boldface limits are tested at +25°C.
R
F
= 402Ω, R
L
= 100Ω, and G = +2, unless otherwise noted. See Figure 1 for AC performance only.
TEST
LEVEL
(3)
OPA2613ID
TEST
LEVEL
(3)
MIN/MAX OVER TEMPERATURETYP
PARAMETER
TEST
LEVEL
(3)
MIN/
MAX
UNITS
−40°C to
+85°C
(2)
0°C to
+70°C
(2)
+25°C
(1)
+25°CTEST CONDITIONS
Power Supply
Specified Operating Voltage ±6 V typ C
Maximum Operating Voltage Range ±6.3 ±6.3 ±6.3 V max A
Maximum Quiescent Current V
S
= ±6V, Both Channels 12 12.4 12.8 13 mA max A
Minimum Quiescent Current V
S
= ±6V, Both Channels 12 11.6 11.2 11 mA min A
Power-Supply Rejection Ratio (−PSRR) Input-Referred 95 90 88 87 dB min A
Thermal Characteristics
Specified Operating Range D Package −40 to +85 °C typ C
Thermal Resistance, q
JA
Junction-to-Ambient
DSO-8 125 °C/W typ C
(1)
Junction temperature = ambient for +25°C tested specifications.
(2)
Junction temperature = ambient at low temperature limit; junction temperature = ambient +23°C at high temperature limit for over temperature
tested specifications.
(3)
Test levels: (A) 100% tested at +25°C. Over temperature limits by characterization and simulation. (B) Limits set by characterization and
simulation. (C) Typical value only for information.
(4)
Current is considered positive-out-of-node. V
CM
is the input common-mode voltage.
(5)
Tested < 3dB below minimum CMRR specification at ± CMIR limits.