Datasheet

IN-
Pre-Output Driver
OUT
V-
V+
IN+
OPA1662
OPA1664
www.ti.com SBOS489 –DECEMBER 2011
APPLICATION INFORMATION
applications do not require equal positive and
The OPA1662 and OPA1664 are unity-gain stable,
negative output voltage swing. With the OPA166x
precision dual and quad op amps with very low noise.
series, power-supply voltages do not need to be
Applications with noisy or high-impedance power
equal. For example, the positive supply could be set
supplies require decoupling capacitors close to the
to +25 V with the negative supply at –5 V.
device pins. In most cases, 0.1-μF capacitors are
adequate. Figure 43 shows a simplified schematic of In all cases, the common-mode voltage must be
the OPA166x (one channel shown). maintained within the specified range. In addition, key
parameters are assured over the specified
temperature range of T
A
= –40°C to +85°C.
OPERATING VOLTAGE
Parameters that vary significantly with operating
The OPA166x series op amps operate from ±1.5 V to
voltage or temperature are shown in the Typical
±18 V supplies while maintaining excellent
Characteristics.
performance. The OPA166x series can operate with
as little as +3 V between the supplies and with up to
+36 V between the supplies. However, some
Figure 43. OPA166x Simplified Schematic
Copyright © 2011, Texas Instruments Incorporated 13
Product Folder Link(s): OPA1662 OPA1664