Other Content

446 Data Collection
▶ Click Experiment > Advanced Set Up > Triggering > Enable.
Disabling an Enabled Trigger
To disable the active trigger.
▶ Click Experiment > Advanced Set Up > Triggering > Disable.
Collecting and Managing Data Sets
By default, the Start Collection button overwrites collected data with data
from the next run. To preserve each run, you can store it as a data set. After
collecting multiple data sets, you can superimpose any combination of them on
the Graph View.
Important: Stored data sets are lost if you close the document without saving it.
If you want stored data to be available later, make sure to save the document.
Storing Data as Sets
1. Collect the data from the first run. (See Collecting Data.)
2. Click the Store Data Set button .
The data is stored as run1. A new data set, run2, is created for collecting
the next run.
3. Click Start Collection to collect data for run2.
Comparing Data Sets
1. Click the Graph View icon to show the graph.
2. Click the Data Set Selector (near the top of the Detail View) to expand the
list of data sets.