Other Content

442 Data Collection
Removing a Data Marker
1. Click to expand the list of markers in the Detail view.
2. In the dialog box, click Remove.
Collecting Data Using a Remote Collection Unit
To collect information from a sensor while it is disconnected, you can set it up
as a remote sensor. Only the TI-Nspire™ Lab Cradle, TI CBR2™, and Vernier
Go!Motion® support remote data collection.
You can set up a remote collection unit to start collecting:
• When you press a manual trigger on the unit, as on the TI-Nspire™ Lab
Cradle
• When a delay countdown expires on a unit that supports a delayed start
Setting Up for Remote Collection
1. Save and close any open documents, and start with a new document.
2. Connect the remote collection unit to the computer or handheld.
3. Modifying Sensor Settings.
4. Click the Collection Setup button .
5. On the Collection Setup screen, check Enable Remote Collection.
6. Select the remote collection unit from the Devices list.
7. Specify the method for starting the collection:
• To start automatically after a specified delay (on supported units), type
the delay value.
• To start when you press the manual trigger (on supported units), type
a delay value of 0. When you use a delay, the manual trigger button
on the TI-Nspire™ Lab Cradle has no effect on the start of the
collection.