Datasheet

USB DAQ

Platform

EVM

Power

Multi-Cal-Master

Multi-Cal-Interface Board

Pressure Sensors in Pressure Manifold

Pressure

Source

±15V

Loop or

DUT

Power

DMM

RS-232 or

IEEE488

www.ti.com

Starter System Setup

2 Starter System Setup

Figure 7 shows the system setup for the Multi-Cal-System EVM. The PC runs software that communicates

with the USB-DAQ-Platform. The USB-DAQ-Platform generates the digital signals used to communicate

with the Multi-Cal-System EVM.

Figure 7. Multi-Cal-System EVM Hardware Setup

2.1 Electrostatic Discharge Warning

Many of the components on the Multi-Cal-System EVM are susceptible to damage by electrostatic

discharge (ESD). Customers are advised to observe proper ESD handling precautions when unpacking

and handling the EVM, including the use of a grounded wrist strap at an approved ESD workstation.

CAUTION

Failure to observe ESD handling procedures may result in damage to EVM

components.

SBOU087A– August 2010– Revised April 2011 Multi-Cal-System Evaluation Module

Submit Documentation Feedback