Datasheet

Multi-Cal-Slave PCA
Multi-Cal-Master PCA
Cable is keyed to
mate with connector
on bottom of Slave PCA
Notch in connector
on bottom of Slave PCA
Expanding the System Size www.ti.com
Now connect the slave ribbon cable to the slave. Make sure to match the key on the ribbon cable with the
notch in the connector, as Figure 25 shows. Note that the cable loop is outside of the master and slave
boards.
Figure 25. Connect Slave Ribbon Cable to Slave
24
Multi-Cal-System Evaluation Module SBOU087A– August 2010– Revised April 2011
Submit Documentation Feedback
Copyright © 2010–2011, Texas Instruments Incorporated