Datasheet

Ribbon cable
keyed to mate
with connector
Notch in
connector
Note that the ribbon
cable points away
from the notch
www.ti.com Expanding the System Size
The next step in expanding the physical system size is to connect the slave ribbon cable to the master;
this step is illustrated in Figure 24. Make sure to match the key on the ribbon cable with the notch in the
connector.
Figure 24. Connect the Ribbon Cable to the Master
23
SBOU087A– August 2010– Revised April 2011 Multi-Cal-System Evaluation Module
Submit Documentation Feedback
Copyright © 2010–2011, Texas Instruments Incorporated