Datasheet

RS-232 connection on
34401A
www.ti.com Starter System Setup
Figure 18 shows connection to the serial port of the DMM for communication. This connection is used in
order to have remote control of the instrument. The other end of the cable is connected to the serial port
on your computer. In order to use this capability, you must set the DMM to RS-232 mode. An optional way
to communicate with the DMM is via the IEEE488 card.
Figure 18. Connect Serial Port to DMM
19
SBOU087A– August 2010– Revised April 2011 Multi-Cal-System Evaluation Module
Submit Documentation Feedback
Copyright © 2010–2011, Texas Instruments Incorporated