Datasheet

Input

Sense

HIHI

VmP

VmN

ImP

ImN

15vP 15vNGND

Multi-Cal-Master-PCA

HP34401

DMM

Voltmeter

plugs are

not connected

Linear

Power Supply

Floating Linear

Power Supply

+15V

GND

-15V

POS NEG

24V

Starter System Setup

www.ti.com

Figure 15 shows how to connect the Multi-Cal-Power cable to power supplies and to the DMM. This

connection is for current loop output sensor modules. Refer to Table 3 for an illustration of how to set the

jumpers on the Multi-Cal-Test PCA for current loop configuration.

NOTE: It is very important that the device power supply is floating. In other words, the negative

terminal on the device power supply is not connected to GND on the ±15-V supply. Also, this

supply should not be referenced to earth ground.

Figure 15. Connect Multi-Cal-Power Cable to Power Supplies (Current Loop Output)

Multi-Cal-System Evaluation Module SBOU087A– August 2010– Revised April 2011

Submit Documentation Feedback