Datasheet

Slave Ribbon Cable

Multi-Cal-Slave PCA

Overview

www.ti.com

1.1 Multi-Cal-Slave Hardware Options

Figure 1 shows the hardware included with the Multi-Cal-Slave EVM. Depending on your specific

hardware requirements, you will use various combinations of the different Multi-Cal-System EVMs in your

application.

The Multi-Cal-Slave EVM contains these items:

• Mutli-Cal-Slave board: This PCB multiplexes all the communication signals, sensor module output

signals, and power.

• Slave Ribbon Cable: This cable connects the Multi-Cal-Slave to the board assembly stacked beneath

it. All of the slave boards in a Multi-Cal-System are interconnected using the Slave Ribbon cable.

Contact the factory if any component is missing.

Figure 1. Hardware Included with the Multi-Cal-Slave EVM Kit

1.2 Related Documentation from Texas Instruments

The following documents provide information regarding Texas Instruments integrated circuits used in the

assembly of the Multi-Cal-Slave EVM. This user's guide is available from the TI website under literature

number SBOU094. Any letter appended to the literature number corresponds to the document revision

that is current at the time of the writing of this document. Newer revisions may be available from the TI

web site at http://www.ti.com/, or call the Texas Instruments Literature Response Center at (800)

477-8924 or the Product Information Center at (972) 644-5580. When ordering, identify the document by

both title and literature number.

Document Literature Number

Multi-Cal-Test EVM User's Guide SBOU088

Multi-Cal-Master EVM User's

SBOU089

Guide

USB DAQ Platform User's Guide SBOU056

Multi-Cal-System EVM User's

SBOU087

Guide

Multi-Cal-Cable User's Guide SBOU092

Multi-Cal-Interface User's Guide SBOU093

Multi-Cal-Slave Evaluation Module SBOU094–September 2010

Submit Documentation Feedback