Datasheet

MSP430G2x32

MSP430G2x02

www.ti.com

SLAS723H –DECEMBER 2010–REVISED MAY 2013

REVISION HISTORY

REVISION DESCRIPTION

SLAS723 Initial release

SLAS723A Page 1, Changed Internal Frequencies up to 16 MHz With One Calibrated Frequency to Four Calibrated Frequencies

Added note concerning pulldown resistor to PW14 and RSA16 pinout drawings.

Removed reference to CAOUT from N20, PW20 pinout drawing and Table 11 (there is no comparator module on this

SLAS723B device).

Added "N20, PW20" to Input Pin Number and Output Pin Number columns in Table 11.

Corrected pin numbers for P1.0 to P1.3 for PW14 package in Table 2.

Corrected N20,PW20 Output Pin Number for TA0.0 in Table 11.

Changed Storage temperature range limit in Absolute Maximum Ratings.

SLAS723C

Removed CAPD.y column from Table 16.

Corrected Control Bits/Signals in Table 20.

Corrected SDA pin name in Table 17.

Changed TAG_ADC10_1 value to 0x10 in Table 9.

SLAS723D

Added P1.6 output row for TA0.1 module output signal TA1 in Table 11.

Changed Tstg, Programmed device, to -55°C to 150°C in Absolute Maximum Ratings.

SLAS723E

Changed all port schematics (added buffer after PxOUT.y mux) in Pin Schematics.

Corrected signal names on pin 7 or "N OR PW PACKAGE" (20 pin) in Device Pinouts.

SLAS723F

Corrected pin number for P2.6 under Ouptput Pin Number, PW14 column in Table 11.

Added note for TC

REF+

in 10-Bit ADC, Built-In Voltage Reference (MSP430G2x32 Only).

Recommended Operating Conditions, Added test conditions for typical values.

SLAS723G

Pin-Oscillator Frequency – Ports Px, Corrected resistor value in note (1).

POR, BOR, Added note (2).

SLAS723H Throughout, Changed all variations of touch sense

(1)

to capacitive touch.

(1) TouchSense is a trademark of Immersion Corporation.