Datasheet

MSP430G22x0
www.ti.com SLAS753E –JANUARY 2012–REVISED FEBRUARY 2013
Schmitt-Trigger Inputs (Port P1)
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
PARAMETER TEST CONDITIONS V
CC
MIN TYP MAX UNIT
0.45 V
CC
0.75 V
CC
V
V
IT+
Positive-going input threshold voltage
3 V 1.35 2.25
0.25 V
CC
0.55 V
CC
V
IT-
Negative-going input threshold voltage V
3 V 0.75 1.65
Input voltage hysteresis
V
hys
3 V 0.3 1.0 V
(V
IT+
- V
IT-
)
For pullup: V
IN
= V
SS
,
R
Pull
Pullup/pulldown resistor 20 35 50 kΩ
For pulldown: V
IN
= V
CC
C
I
Input capacitance V
IN
= V
SS
or V
CC
5 pF
Leakage Current (Port P1)
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
PARAMETER TEST CONDITIONS V
CC
MIN MAX UNIT
I
lkg(Px.y)
High-impedance leakage current
(1) (2)
/3 V ±50 nA
(1) The leakage current is measured with V
SS
or V
CC
applied to the corresponding pin(s), unless otherwise noted.
(2) The leakage of the digital port pins is measured individually. The port pin is selected for input and the pullup/pulldown resistor is
disabled.
Outputs (Port P1)
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
PARAMETER TEST CONDITIONS V
CC
MIN TYP MAX UNIT
V
OH
High-level output voltage I
(OHmax)
= -6 mA
(1)
3 V V
CC
- 0.6 V
CC
V
V
OL
Low-level output voltage I
(OLmax)
= 6 mA
(1)
3 V V
SS
V
SS
+ 0.6 V
(1) The maximum total current, I
(OHmax)
and I
(OLmax)
, for all outputs combined should not exceed ±48 mA to hold the maximum voltage drop
specified.
Output Frequency (Port P1)
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
PARAMETER TEST CONDITIONS V
CC
MIN TYP MAX UNIT
Port output frequency
f
Px.y
C
L
= 20 pF, R
L
= 1 kΩ
(1) (2)
3 V 12 MHz
(with load)
f
Port°CLK
Clock output frequency C
L
= 20 pF
(2)
3 V 16 MHz
(1) A resistive divider with two 0.5-kΩ resistors between V
CC
and V
SS
is used as load. The output is connected to the center tap of the
divider.
(2) The output voltage reaches at least 10% and 90% V
CC
at the specified toggle frequency.
Copyright © 2012–2013, Texas Instruments Incorporated Submit Documentation Feedback 17