Datasheet

f (MHz)
1.8 V 3.6 V2.7 V 3 V
4.15 MHz
8 MHz
V
CC
− Supply Voltage − V
f
(System)
− Maximum Processor Frequency − MHz
Supply V oltage Range During
Program Execution
Supply V oltage Range
During Programming of
the Flash Memory
MSP430FW42x
www.ti.com SLAS383D –OCTOBER 2003–REVISED JANUARY 2011
Absolute Maximum Ratings
(1)
over operating free-air temperature range (unless otherwise noted)
Voltage applied at V
CC
to V
SS
-0.3 V to 4.1 V
Voltage applied to any pin
(2)
-0.3 V to V
CC
+ 0.3 V
Diode current at any device terminal ±2 mA
Unprogrammed device -55°C to 150°C
Storage temperature range, T
stg
Programmed device -40°C to 85°C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltages referenced to V
SS
.The JTAG fuse-blow voltage, V
FB
, is allowed to exceed the absolute maximum rating. The voltage is
applied to the TDI/TCLK pin when blowing the JTAG fuse.
Recommended Operating Conditions
MIN NOM MAX UNIT
V
CC
Supply voltage during program execution
(1)
(AV
CC
= DV
CC1
= DV
CC2
= V
CC
) 1.8 3.6 V
Supply voltage during program execution, SVS enabled, PORON = 1
(1) (2)
V
CC
2 3.6 V
(AV
CC
= DV
CC1
= DV
CC2
= V
CC
)
V
CC
Supply voltage during flash memory programming
(1)
(AV
CC
= DV
CC1
= DV
CC2
= V
CC
) 2.7 3.6 V
V
SS
Supply voltage (AV
SS
= DV
SS1
= DV
SS2
= V
SS
) 0 0 V
T
A
Operating free-air temperature range -40 85 °C
LF selected, XTS_FLL = 0 Watch crystal 32.768
f
(LFXT1)
LFXT1 crystal frequency
(3)
XT1 selected, XTS_FLL = 1 Ceramic resonator 450 8000 kHz
XT1 selected, XTS_FLL = 1 Crystal 1000 8000
V
CC
= 1.8 V DC 4.15
Processor frequency (signal
f
(System)
MHz
MCLK)
V
CC
= 3.6 V DC 8
(1) It is recommended to power AV
CC
and DV
CC
from the same source. A maximum difference of 0.3 V between AV
CC
and DV
CC
can be
tolerated during power up and operation.
(2) The minimum operating supply voltage is defined according to the trip point where POR is going active by decreasing the supply
voltage. POR is going inactive when the supply voltage is raised above the minimum supply voltage plus the hysteresis of the SVS
circuitry.
(3) In LF mode, the LFXT1 oscillator requires a watch crystal. In XT1 mode, LFXT1 accepts a ceramic resonator or a crystal.
Figure 1. Maximum Frequency vs Supply Voltage
Copyright © 2003–2011, Texas Instruments Incorporated Submit Documentation Feedback 19