Datasheet

MSP430FW42x
SLAS383D –OCTOBER 2003–REVISED JANUARY 2011 www.ti.com
Scan Interface
The scan interface is used to measure linear or rotational motion and supports LC and resistive sensors such as
GMR sensors. The scan IF incorporates a V
CC
/2 generator, a comparator, and a 10-bit DAC and supports up to
four sensors.
Timer0_A3
Timer0_A3 is a 16-bit timer/counter with three capture/compare registers. Timer_A3 can support multiple
capture/compares, PWM outputs, and interval timing. Timer0_A3 also has extensive interrupt capabilities.
Interrupts may be generated from the counter on overflow conditions and from each of the capture/compare
registers.
Table 7. Timer0_A3 Signal Connections
DEVICE INPUT MODULE INPUT MODULE OUTPUT OUTPUT PIN
INPUT PIN NUMBER MODULE BLOCK
SIGNAL NAME SIGNAL NUMBER
48 - P1.5 TA0CLK TACLK
ACLK ACLK
Timer NA
SMCLK SMCLK
48 - P1.5 TA0CLK INCLK
53 - P1.0 TA0.0 CCI0A 53 - P1.0
52 - P1.1 TA0.0 CCI0B
CCR0 TA0.0
DV
SS
GND
DV
CC
V
CC
51 - P1.2 TA0.1 CCI1A 51 - P1.2
CAOUT (internal) CCI1B
CCR1 TA0.1
DV
SS
GND
DV
CC
V
CC
45 - P2.0 TA0.2 CCI2A 45 - P2.0
ACLK (internal) CCI2B
CCR2 TA0.2
DV
SS
GND
DV
CC
V
CC
14 Submit Documentation Feedback Copyright © 2003–2011, Texas Instruments Incorporated