Datasheet
Table Of Contents
- features
- description
- Available Options
- pin designation
- functional block diagram
- Terminal Functions
- short-form description
- absolute maximum ratings
- recommended operating conditions
- electrical characteristics over recommended operating free-air temperature
- supply current into AVCC + DVCC excluding external
- current consumption of active mode versus system frequency
- current consumption of active mode versus supply voltage
- Schmitt-trigger inputs -- Ports P1 and P2, RST/NMI, JTAG (TCK, TMS, TDI/TCLK, TDO/TDI)
- inputs Px.x, TAx
- leakage current
- outputs -- Ports P1 and P2
- output frequency
- wake-up LPM3
- RAM
- LCD
- USART0
- POR brownout, reset
- SVS (supply voltage supervisor/monitor)
- DCO
- crystal oscillator, LFXT1 oscillator
- SD16, power supply and recommended operating conditions
- SD16, analog input range
- SD16, analog performance (fSD16 = 1MHz, SD16OSRx = 256, SD16REFON = 1)
- SD16, built-in voltage reference
- SD16, built-in reference output buffer
- SD16, external reference input
- flash memory
- JTAG interface
- JTAG fuse
- Application Information
- input/output schematic
- Port P1, P1.0 to P1.1, input/output with Schmitt trigger
- Port P1, P1.2 to P1.7, input/output with Schmitt trigger
- Port P2, P2.0 to P2.1, input/output with Schmitt trigger
- Port P2, P2.2 to P2.5, input/output with Schmitt trigger
- Port P2, unbonded GPIOs P2.6 and P2.7
- JTAG pins (TMS, TCK, TDI/TCLK, TDO/TDI), input/output with Schmitt trigger or output
- JTAG fuse check mode
- input/output schematic
- Data Sheet Revision History
MSP430F42xA
MIXED SIGNAL MICROCONTROLLER
SLAS587 -- FEBRUARY 2008
36
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
APPLICATION INFORMATION
input/output schematic (continued)
Port P2, unbonded GPIOs P2.6 and P2.7
EN
D
0
1
0
1
Interrupt
Edge
Select
EN
Set
Q
P2IE.x
P2IFG.x
P2IRQ.x
Interrupt
Flag
P2IES.x
P2SEL.x
Module X IN
P2IN.x
P2OUT.x
Module X OUT
Direction Control
From Module
P2DIR.x
P2SEL.x
Bus Keeper
0
1
0: Input
1: Output
Node Is Reset With PUC
PUC
NOTE: x = Bit/identifier, 6 to 7 for port P2 without external pins
P2Sel.x
P2DIR.x
DIRECTION
CONTROL
FROM MODULE
P2OUT.x MODULE X OUT P2IN.x MODULE X IN P2IE.x P2IFG.x P2IES.x
P2Sel.6 P2DIR.6 P2DIR.6 P2OUT.6 DV
SS
P2IN.6 unused P2IE.6 P2IFG.6 P2IES.6
P2Sel.7 P2DIR.7 P2DIR.7 P2OUT.7 DV
SS
P2IN.7 unused P2IE.7 P2IFG.7 P2IES.7
NOTE: Unbonded GPIOs 6 and 7 of port P2 can be used as interrupt flags. Only software can affect the interrupt flags. They work as software
interrupts.