Datasheet
Table Of Contents
- features
- description
- Available Options
- pin designation
- functional block diagram
- Terminal Functions
- short-form description
- absolute maximum ratings
- recommended operating conditions
- electrical characteristics over recommended operating free-air temperature
- supply current into AVCC + DVCC excluding external
- current consumption of active mode versus system frequency
- current consumption of active mode versus supply voltage
- Schmitt-trigger inputs -- Ports P1 and P2, RST/NMI, JTAG (TCK, TMS, TDI/TCLK, TDO/TDI)
- inputs Px.x, TAx
- leakage current
- outputs -- Ports P1 and P2
- output frequency
- wake-up LPM3
- RAM
- LCD
- USART0
- POR brownout, reset
- SVS (supply voltage supervisor/monitor)
- DCO
- crystal oscillator, LFXT1 oscillator
- SD16, power supply and recommended operating conditions
- SD16, analog input range
- SD16, analog performance (fSD16 = 1MHz, SD16OSRx = 256, SD16REFON = 1)
- SD16, built-in voltage reference
- SD16, built-in reference output buffer
- SD16, external reference input
- flash memory
- JTAG interface
- JTAG fuse
- Application Information
- input/output schematic
- Port P1, P1.0 to P1.1, input/output with Schmitt trigger
- Port P1, P1.2 to P1.7, input/output with Schmitt trigger
- Port P2, P2.0 to P2.1, input/output with Schmitt trigger
- Port P2, P2.2 to P2.5, input/output with Schmitt trigger
- Port P2, unbonded GPIOs P2.6 and P2.7
- JTAG pins (TMS, TCK, TDI/TCLK, TDO/TDI), input/output with Schmitt trigger or output
- JTAG fuse check mode
- input/output schematic
- Data Sheet Revision History
MSP430F42xA
MIXED SIGNAL MICROCONTROLLER
SLAS587 -- FEBRUARY 2008
26
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
electrical characteristics over recommended operating free-air temperature (unless otherwise
noted) (continued)
12720
1.11
1.17
DCO Tap
S
n
- S tepsize Ratio Between DCO Taps
Min
Max
1.07
1.06
Figure 12. DCO Tap Step Size
DCO Frequency
Adjusted by Bits
2
9
to 2
5
in SCFI1 {N
{DCO}
}
FN_2=0
FN_3=0
FN_4=0
FN_8=0
FN_2=1
FN_3=0
FN_4=0
FN_8=0
FN_2=x
FN_3=1
FN_4=0
FN_8=0
FN_2=x
FN_3=x
FN_4=1
FN_8=0
FN_2=x
FN_3=x
FN_4=x
FN_8=1
Legend
Tolerance at Tap 27
Tolerance at Tap 2
Overlapping DCO Ranges:
Uninterrupted Frequency Range
f
(DCO)
Figure 13. Five Overlapping DCO Ranges Controlled by FN_x Bits