Datasheet
Table Of Contents
- features
- description
- Available Options
- pin designation
- functional block diagram
- Terminal Functions
- short-form description
- absolute maximum ratings
- recommended operating conditions
- electrical characteristics over recommended operating free-air temperature
- supply current into AVCC + DVCC excluding external
- current consumption of active mode versus system frequency
- current consumption of active mode versus supply voltage
- Schmitt-trigger inputs -- Ports P1 and P2, RST/NMI, JTAG (TCK, TMS, TDI/TCLK, TDO/TDI)
- inputs Px.x, TAx
- leakage current
- outputs -- Ports P1 and P2
- output frequency
- wake-up LPM3
- RAM
- LCD
- USART0
- POR brownout, reset
- SVS (supply voltage supervisor/monitor)
- DCO
- crystal oscillator, LFXT1 oscillator
- SD16, power supply and recommended operating conditions
- SD16, analog input range
- SD16, analog performance (fSD16 = 1MHz, SD16OSRx = 256, SD16REFON = 1)
- SD16, built-in voltage reference
- SD16, built-in reference output buffer
- SD16, external reference input
- flash memory
- JTAG interface
- JTAG fuse
- Application Information
- input/output schematic
- Port P1, P1.0 to P1.1, input/output with Schmitt trigger
- Port P1, P1.2 to P1.7, input/output with Schmitt trigger
- Port P2, P2.0 to P2.1, input/output with Schmitt trigger
- Port P2, P2.2 to P2.5, input/output with Schmitt trigger
- Port P2, unbonded GPIOs P2.6 and P2.7
- JTAG pins (TMS, TCK, TDI/TCLK, TDO/TDI), input/output with Schmitt trigger or output
- JTAG fuse check mode
- input/output schematic
- Data Sheet Revision History

MSP430F42xA
MIXED SIGNAL MICROCONTROLLER
SLAS587 -- FEBRUARY 2008
22
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
electrical characteristics over recommended operating free-air temperature (unless otherwise
noted) (continued)
0
1
V
V
CC(start)
V
hys(B_IT--)
V
CC
t
d(BOR)
(B_IT--)
Figure 6. POR/Brownout Reset (BOR) vs Supply Voltage
V
CC
(drop) -- V
0
0.5
1
1.5
2
0.001 1 1000
V=3V
Typical Conditions
1ns 1ns
t
pw
-- Pulse Width -- μst
pw
-- Pulse Width -- μs
cc
V
CC
3V
V
CC(drop)
t
pw
Figure 7. V
CC(drop)
Level With a Square Voltage Drop to Generate a POR/Brownout Signal
V
CC
3V
V
CC(drop)
t
pw
0
0.5
1
1.5
2
t
pw
-- Pulse Width -- μs
0.001 1 1000
t
f
t
r
t
pw
-- Pulse Width -- μs
t
f=
t
r
V=3V
Typical Conditions
cc
V
CC
(drop) -- V
Figure 8. V
CC(drop)
Level With a Triangle Voltage Drop to Generate a POR/Brownout Signal