Datasheet
Table Of Contents
- features
- description
- Available Options
- pin designation
- functional block diagram
- Terminal Functions
- short-form description
- absolute maximum ratings
- recommended operating conditions
- electrical characteristics over recommended operating free-air temperature
- supply current into AVCC + DVCC excluding external
- current consumption of active mode versus system frequency
- current consumption of active mode versus supply voltage
- Schmitt-trigger inputs -- Ports P1 and P2, RST/NMI, JTAG (TCK, TMS, TDI/TCLK, TDO/TDI)
- inputs Px.x, TAx
- leakage current
- outputs -- Ports P1 and P2
- output frequency
- wake-up LPM3
- RAM
- LCD
- USART0
- POR brownout, reset
- SVS (supply voltage supervisor/monitor)
- DCO
- crystal oscillator, LFXT1 oscillator
- SD16, power supply and recommended operating conditions
- SD16, analog input range
- SD16, analog performance (fSD16 = 1MHz, SD16OSRx = 256, SD16REFON = 1)
- SD16, built-in voltage reference
- SD16, built-in reference output buffer
- SD16, external reference input
- flash memory
- JTAG interface
- JTAG fuse
- Application Information
- input/output schematic
- Port P1, P1.0 to P1.1, input/output with Schmitt trigger
- Port P1, P1.2 to P1.7, input/output with Schmitt trigger
- Port P2, P2.0 to P2.1, input/output with Schmitt trigger
- Port P2, P2.2 to P2.5, input/output with Schmitt trigger
- Port P2, unbonded GPIOs P2.6 and P2.7
- JTAG pins (TMS, TCK, TDI/TCLK, TDO/TDI), input/output with Schmitt trigger or output
- JTAG fuse check mode
- input/output schematic
- Data Sheet Revision History

MSP430F42xA
MIXED SIGNAL MICROCONTROLLER
SLAS587 -- FEBRUARY 2008
20
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
electrical characteristics over recommended operating free-air temperature (unless otherwise
noted) (continued)
outputs -- Ports P1 and P2 (continued)
Figure 2
V
OL
-- Low-Level Output Voltage -- V
0
5
10
15
20
25
30
0.0 0.5 1.0 1.5 2.0 2.5
V
CC
=2.2V
P2.1
TYPICAL LOW-LEVEL OUTPUT CURRENT
vs
LOW-LEVEL OUTPUT VOLTAGE
T
A=
25°C
T
A=
85°C
OL
I
-- Typical Low-Level Output Current -- mA
Figure 3
V
OL
-- Low-Level Output Voltage -- V
0
10
20
30
40
50
0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5
V
CC
=3V
P2.1
TYPICAL LOW-LEVEL OUTPUT CURRENT
vs
LOW-LEVEL OUTPUT VOLTAGE
T
A=
25°C
T
A=
85°C
OL
I
-- Typical Low-Level Output Current -- mA
Figure 4
V
OH
-- High-Level Output Voltage -- V
-- 3 0
-- 2 5
-- 2 0
-- 1 5
-- 1 0
-- 5
0
0.0 0.5 1.0 1.5 2.0 2.5
V
CC
=2.2V
P2.1
TYPICAL HIGH-LEVEL OUTPUT CURRENT
vs
HIGH-LEVEL OUTPUT VOLTAGE
T
A=
25°C
T
A=
85°C
OL
I
-- Typical High-Level Output Current -- m
A
Figure 5
V
OH
-- High-Level Output Voltage -- V
-- 5 0
-- 4 0
-- 3 0
-- 2 0
-- 1 0
0
0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5
V
CC
=3V
P2.1
TYPICAL HIGH-LEVEL OUTPUT CURRENT
vs
HIGH-LEVEL OUTPUT VOLTAGE
T
A=
25°C
T
A=
85°C
OL
I
-- Typical High-Level Output Current -- mA
NOTE: One output loaded at a time