Datasheet

MSP430F23x0
MIXED SIGNAL MICROCONTROLLER
SLAS518A -- AUGUST 2006 -- REVISED MAY 2007
24
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
electrical characteristics over recommended ranges of supply voltage and operating free-air
temperature (unless otherwise noted) (continued)
POR/brownout reset (BOR) (see Notes 1 and 2)
PARAMETER TEST CONDITIONS VCC MIN TYP MAX UNIT
V
CC(start)
(see Figure 8) dV
CC
/dt ≤ 3V/s 0.7 × V
(B_IT--)
V
V
(B_IT--)
(see Figure 8 through Figure 10) dV
CC
/dt ≤ 3V/s 1.71 V
V
hys(B_IT--)
(see Figure 8) dV
CC
/dt ≤ 3V/s 70 130 210 mV
t
d(BOR)
(see Figure 8) 2000 μs
t
(reset)
Pulse length needed at RST/NMI pin
to accepted reset internally
2.2 V/3 V 2 μs
NOTES: 1. The current consumption of the brownout module is already included in the I
CC
current consumption data. The voltage level V
(B_IT--)
+V
hys(B_IT--)
is ≤ 1.8V.
2. During power up, the CPU begins code execution following a period of t
d(BOR)
after V
CC
=V
(B_IT--)
+V
hys(B_IT--)
. The default
DCO settings must not be changed until V
CC
≥ V
CC(min)
, where V
CC(min)
is the minimum supply voltage for the desired
operating frequency.
0
1
t
d(BOR)
V
CC
V
(B_IT--)
V
hys(B_IT--)
V
CC(start)
Figure 8. POR/Brownout Reset (BOR) vs Supply Voltage