Datasheet

www.ti.com MSP-TS430RGC64USB
B.20 MSP-TS430RGC64USB
Due to the use of diodes in the power chain, the voltage on the MSP430F5xx device is approximately
0.3 V lower than is set by the debugging tool. Set the voltage in the IDE to 0.3 V higher than desired; for
example, to run the MCU at 3.0 V, set it to 3.3 V.
Figure B-39. MSP-TS430RGC64USB Target Socket Module, Schematic
89
SLAU278Q–May 2009–Revised February 2014 Hardware
Submit Documentation Feedback
Copyright © 2009–2014, Texas Instruments Incorporated