Datasheet

ECCN 5E002 TSPA - Technology / Software Publicly Available
CC430F6137, CC430F6135, CC430F6127, CC430F6126, CC430F6125
CC430F5137, CC430F5135, CC430F5133
www.ti.com SLAS554H –MAY 2009–REVISED SEPTEMBER 2013
RF Transmit
T
A
= 25°C, V
CC
= 3 V (unless otherwise noted)
(1)
P
TX
= +10 dBm (unless otherwise noted)
FREQUENCY
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
(MHz)
315 122 + j31
Differential load
433 116 + j41 Ω
impedance
(2)
868, 915 86.5 + j43
315 +12
433 +13
Output power, highest Delivered to a 50Ω single-ended load via CC430
dBm
setting
(3)
reference design's RF matching network
868 +11
915 +11
Output power, lowest Delivered to a 50Ω single-ended load via CC430
-30 dBm
setting
(3)
reference design's RF matching network
Second harmonic -56
433
Third harmonic -57
Second harmonic -50
Harmonics,
868 dBm
radiated
(4)(5)(6)
Third harmonic -52
Second harmonic -50
915
Third harmonic -54
Frequencies below 960 MHz < -38
315 +10 dBm CW
Frequencies above 960 MHz < -48
Frequencies below 1 GHz -45
433 +10 dBm CW
Frequencies above 1 GHz < -48
Harmonics, conducted dBm
Second harmonic -59
868 +10 dBm CW
Other harmonics < -71
Second harmonic -53
915 +11 dBm CW
(7)
Other harmonics < -47
Frequencies below 960 MHz < -58
315 +10 dBm CW
Frequencies above 960 MHz < -53
Frequencies below 1 GHz < -54
Frequencies above 1 GHz < -54
433 +10 dBm CW
Frequencies within 47 to 74, 87.5 to
< -63
Spurious emissions,
118, 174 to 230, 470 to 862 MHz
conducted, harmonics dBm
Frequencies below 1 GHz < -46
not included
(8)
Frequencies above 1 GHz < -59
868 +10 dBm CW
Frequencies within 47 to 74, 87.5 to
< -56
118, 174 to 230, 470 to 862 MHz
Frequencies below 960 MHz < -49
915 +11 dBm CW
Frequencies above 960 MHz < -63
(1) All measurement results are obtained using the EM430F6137RF900 with BOM according to tested frequency range (see Table 48).
(2) Differential impedance as seen from the RF-port (RF_P and RF_N) towards the antenna. Follow the CC430 reference designs available
from the TI website.
(3) Output power is programmable, and full range is available in all frequency bands. Output power may be restricted by regulatory limits.
See also application note AN050 Using the CC1101 in the European 868MHz SRD Band (SWRA146) and design note DN013
Programming Output Power on CC1101 (SWRA168), which gives the output power and harmonics when using multi-layer inductors.
The output power is then typically +10 dBm when operating at 868 or 915 MHz.
(4) The antennas used during the radiated measurements (SMAFF-433 from R.W.Badland and Nearson S331 868/915) play a part in
attenuating the harmonics.
(5) Measured on EM430F6137RF900 with CW, maximum output power
(6) All harmonics are below -41.2 dBm when operating in the 902 to 928 MHz band.
(7) Requirement is -20 dBc under FCC 15.247
(8) All radiated spurious emissions are within the limits of ETSI. Also see design note DN017 CC11xx 868/915 MHz RF Matching
(SWRA168).
Copyright © 2009–2013, Texas Instruments Incorporated Submit Documentation Feedback 81
Product Folder Links: CC430F6137 CC430F6135 CC430F6127 CC430F6126 CC430F6125 CC430F5137
CC430F5135 CC430F5133