Datasheet

ECCN 5E002 TSPA - Technology / Software Publicly Available
CC430F6137, CC430F6135, CC430F6127, CC430F6126, CC430F6125
CC430F5137, CC430F5135, CC430F5133
www.ti.com SLAS554H –MAY 2009–REVISED SEPTEMBER 2013
USCI (SPI Slave Mode)
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
(see Note
(1)
, Figure 17 and Figure 18)
PARAMETER TEST CONDITIONS PMMCOREVx V
CC
MIN TYP MAX UNIT
1.8 V 11
0 ns
3.0 V 8
t
STE,LEAD
STE lead time, STE low to clock
2.4 V 7
3
3.0 V 6
1.8 V 3
0 ns
3.0 V 3
STE lag time, Last clock to STE
t
STE,LAG
high
2.4 V 3
3
3.0 V 3
1.8 V 66
0 ns
3.0 V 50
STE access time, STE low to
t
STE,ACC
SOMI data out
2.4 V 36
3
3.0 V 30
1.8 V 30
0 ns
3.0 V 23
STE disable time, STE high to
t
STE,DIS
SOMI high impedance
2.4 V 16
3
3.0 V 13
1.8 V 5
0 ns
3.0 V 5
t
SU,SI
SIMO input data setup time
2.4 V 2
3 ns
3.0 V 2
1.8 V 5
0 ns
3.0 V 5
t
HD,SI
SIMO input data hold time
2.4 V 5
3 ns
3.0 V 5
1.8 V 76
0 ns
3.0 V 60
UCLK edge to SOMI valid,
t
VALID,SO
SOMI output data valid time
(2)
C
L
= 20 pF
2.4 V 44
3 ns
3.0 V 40
1.8 V 18
0 ns
3.0 V 12
t
HD,SO
SOMI output data hold time
(3)
C
L
= 20 pF
2.4 V 10
3 ns
3.0 V 8
(1) f
UCxCLK
= 1/2t
LO/HI
with t
LO/HI
≥ max(t
VALID,MO(Master)
+ t
SU,SI(USCI)
, t
SU,MI(Master)
+ t
VALID,SO(USCI)
).
For the master's parameters t
SU,MI(Master)
and t
VALID,MO(Master)
see the SPI parameters of the attached master.
(2) Specifies the time to drive the next valid data to the SOMI output after the output changing UCLK clock edge. See the timing diagrams
in Figure 15 and Figure 16.
(3) Specifies how long data on the SOMI output is valid after the output changing UCLK clock edge. See the timing diagrams in Figure 15
and Figure 16.
Copyright © 2009–2013, Texas Instruments Incorporated Submit Documentation Feedback 59
Product Folder Links: CC430F6137 CC430F6135 CC430F6127 CC430F6126 CC430F6125 CC430F5137
CC430F5135 CC430F5133