Datasheet

LP2952-N, LP2952A, LP2953, LP2953A

www.ti.com

SNVS095D –MAY 2004–REVISED SEPTEMBER 2013

The KOVAR lead frame does not conduct heat as well as copper, which means that the PC board copper can

not be used to significantly reduce the overall junction-to-ambient thermal resistance in applications using the

LP2953AMJ part.

The power dissipation calculations for military applications are done exactly the same as was detailed in the

previous section, with one important exception: the value for θ

(J–A)

, the junction-to-ambient thermal resistance, is

fixed at 95°C/W and can not be changed by adding copper foil patterns to the PC board. This leads to an

important fact: The maximum allowable power dissipation in any application using the LP2953AMJ is dependent

only on the ambient temperature:

(2)

Figure 36 shows a graph of maximum allowable power dissipation vs. ambient temperature for the LP2953AMJ,

made using the 95°C/W value for θ

(J–A)

and assuming a maximum junction temperature of 150°C (caution: the

maximum ambient temperature which will be reached in a given application must always be used to calculate

maximum allowable power dissipation).

External Capacitors

A 2.2 μF (or greater) capacitor is required between the output pin and ground to assure stability when the output

is set to 5V. Without this capacitor, the part will oscillate. Most type of tantalum or aluminum electrolytics will

work here. Film types will work, but are more expensive. Many aluminum electrolytics contain electrolytes which

freeze at −30°C, which requires the use of solid tantalums below −25°C. The important parameters of the

capacitor are an ESR of about 5Ω or less and a resonant frequency above 500 kHz (the ESR may increase by a

factor of 20 or 30 as the temperature is reduced from 25°C to −30°C). The value of this capacitor may be

increased without limit.

At lower values of output current, less output capacitance is required for stability. The capacitor can be reduced

to 0.68 μF for currents below 10 mA or 0.22 μF for currents below 1 mA.

Programming the output for voltages below 5V runs the error amplifier at lower gains requiring more output

capacitance for stability. At 3.3V output, a minimum of 4.7 μF is required. For the worst-case condition of 1.23V

output and 250 mA of load current, a 6.8 μF (or larger) capacitor should be used.

A 1 μF capacitor should be placed from the input pin to ground if there is more than 10 inches of wire between

the input and the AC filter capacitor or if a battery input is used.

Stray capacitance to the Feedback terminal can cause instability. This problem is most likely to appear when

using high value external resistors to set the output voltage. Adding a 100 pF capacitor between the Output and

Feedback pins and increasing the output capacitance to 6.8 μF (or greater) will cure the problem.

Minimum Load

When setting the output voltage using an external resistive divider, a minimum current of 1 μA is recommended

through the resistors to provide a minimum load.

It should be noted that a minimum load current is specified in several of the electrical characteristic test

conditions, so this value must be used to obtain correlation on these tested limits.

Product Folder Links: LP2952-N LP2952A LP2953 LP2953A