Datasheet

PGND/EP
Connect to AGND
5
AGND
6
AGND
3
AGND
1
VIN
2
VIN
4
EN
7
FB
SS
9
NC
10
VOUT
11
VOUT
8
LMZ13610
www.ti.com SNVS709E –MARCH 2011–REVISED OCTOBER 2013
Connection Diagram
Figure 5. Top View
11-Lead PFM
PIN DESCRIPTIONS
Pin Name Description
1, 2 VIN Supply input — Nominal operating range is 6V to 36V. A small amount of internal capacitance is contained within the
package assembly. Additional external input capacitance is required between this pin and PGND.
3, 5, AGND Analog Ground — Reference point for all stated voltages. Must be externally connected to EP/PGND.
6
4 EN Enable — Input to the precision enable comparator. Rising threshold is 1.274V typical. Once the module is enabled, a 20
uA source current is internally activated to accommodate programmable hysteresis.
7 FB Feedback — Internally connected to the regulation, over-voltage, and short-circuit comparators. The regulation reference
point is 0.8V at this input pin. Connect the feedback resistor divider between the output and AGND to set the output
voltage.
8 SS Soft-Start/Track input — To extend the 1.6 mSec internal soft-start connect an external soft start capacitor. For tracking
connect to an external resistive divider connected to a higher priority supply rail. See Design Steps for the LMZ13610
Application section.
9 NC No Connect. This pin must remain floating, do not ground.
10, VOUT Output Voltage — Output from the internal inductor. Connect the output capacitor between this pin and PGND.
11
EP PGND Exposed Pad / Power Ground Electrical path for the power circuits within the module. — NOT Internally connected to
AGND / pin 5. Used to dissipate heat from the package during operation. Must be electrically connected to pin 5 external
to the package.
Copyright © 2011–2013, Texas Instruments Incorporated Submit Documentation Feedback 3
Product Folder Links: LMZ13610