Datasheet

November 2013 LMX2531-xxxx Evaluation Board User’s Guide SNAU077A 5
Copyright © 2013, Texas Instruments Incorporated
www.ti.com
Basic Operation
1. Connect the signal generator output to the OSCin input of the board. For this example we use a 10 MHz sin
signal at +5dBm power level.
2. Connect a low noise 3.3 V power supply to the Vcc connector located at the top left of the board.
3. Please see Appendix D for quick start on interfacing the board. Connect PC to the uWire header.
Laptop or PC
Laptop or PC
Power
Supply
Power
Cable
Power
Cable
3.0 V
Sig Gen
SMA
cable
SMA
cable
1
3
Please see
Appendix D for
interface info
Please see
Appendix D for
interface info
2
OSCin
Vcc
uWire
header
10 MHz @
+5 dBm
4. Start CodeLoader4.exe.
5. Select USB or LPT Communication Mode on the Port Setup tab as appropriate.
Appendix C for