Datasheet

INPUT
OUTPUT
V
DD
10 pF 33 pF
LMV1012
www.ti.com SNAS194H –NOVEMBER 2002–REVISED MAY 2013
NOISE
Noise pick-up by a microphone in cell phones is a well-known problem. A conventional JFET circuit is sensitive
for noise pick-up because of its high output impedance, which is usually around 2.2 kΩ.
RF noise is amongst other caused by non-linear behavior. The non-linear behavior of the amplifier at high
frequencies, well above the usable bandwidth of the device, causes AM-demodulation of high frequency signals.
The AM modulation contained in such signals folds back into the audio band, thereby disturbing the intended
microphone signal. The GSM signal of a cell phone is such an AM-modulated signal. The modulation frequency
of 216 Hz and its harmonics can be observed in the audio band. This kind of noise is called bumblebee noise.
RF noise caused by a GSM signal can be reduced by connecting two external capacitors to ground, see
Figure 26. One capacitor reduces the noise caused by the 900 MHz carrier and the other reduces the noise
caused by 1800/1900 MHz.
Figure 26. RF Noise Reduction
Copyright © 2002–2013, Texas Instruments Incorporated Submit Documentation Feedback 13
Product Folder Links: LMV1012