Datasheet

LMP2234
SNOSAW4D –SEPTEMBER 2007–REVISED MARCH 2013 www.ti.com
1.8V AC Electrical Characteristics
(1)
Unless otherwise is specified, all limits are ensured for T
A
= 25°C, V
+
= 1.8V, V
−
= 0V, V
CM
= V
O
= V
+
/2, and R
L
> 1 MΩ.
Boldface limits apply at the temperature extremes.
Symbol Parameter Conditions Min Typ Max Units
(2) (3) (2)
GBWP Gain Bandwidth Product C
L
= 20 pF, R
L
= 10 kΩ 127 kHz
SR Slew Rate A
V
= +1, C
L
= 20 pF Falling Edge 58
V/ms
R
L
= 10 kΩ
Rising Edge 48
θ
m
Phase Margin C
L
= 20 pF, R
L
= 10 kΩ 70 deg
G
m
Gain Margin C
L
= 20 pF, R
L
= 10 kΩ 25 dB
e
n
Input-Referred Voltage Noise Density f = 1 kHz 60 nV/√Hz
Input-Referred Voltage Noise 0.1 Hz to 10 Hz 2.4 μV
PP
i
n
Input-Referred Current Noise Density f = 1 kHz 10 fA/√Hz
THD+N Total Harmonic Distortion + Noise f = 100 Hz, R
L
= 10 kΩ 0.005 %
(1) Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very
limited self-heating of the device such that T
J
= T
A
. No ensured specification of parametric performance is indicated in the electrical
tables under conditions of internal self-heating where T
J
> T
A
. Absolute Maximum Ratings indicate junction temperature limits beyond
which the device may be permanently degraded, either mechanically or electrically.
(2) All limits are specified by testing, statistical analysis or design.
(3) Typical values represent the most likely parametric norm as determined at the time of characterization. Actual typical values may vary
over time and will also depend on the application and configuration. The typical values are not tested and are not ensured on shipped
production material.
Connection Diagram
Figure 2. 14-Pin TSSOP/SOIC
8 Submit Documentation Feedback Copyright © 2007–2013, Texas Instruments Incorporated
Product Folder Links: LMP2234