Datasheet

L M K 0 4 1 X X - R E V 3 E V A L U A T I O N B O A R D O P E R A T I N G I N S T R U C T I O N S
SNLU099
12
Bits/Pins Tab
Figure 6 - Bits/Pins tab.
The Bits/Pins tab allows the user to program bits directly. Many of which are not available on
other tabs. Refer to the datasheet for more detailed information. The bits available are:
Common Box
o RESET - Set the reset bit. This will reset the device. In a normal application it is
not necessary to program this bit clear since it is auto-clearing. However in the
CodeLoader software, RESET must be clicked again (cleared) to not cause a reset
every time R7 is programmed.
o POWERDOWN - Place the device in powerdown mode.
o EN_Fout – Enable the Fout port.
PLL Box
o PLL_MUX – Set the function of the LD pin.
o RC_DLD1_Start – Prevent PLL2 from locking until digital lock detect from
PLL1 is achieved.