Datasheet

November 2013 LMK3806 Evaluation Board SNAU075A 7
Copyright © 2013, Texas Instruments Incorporated
3. Default CodeLoader Modes for Evaluation Boards
CodeLoader saves the state of the selected LMK03806B device when exiting the software. To ensure a
common starting point, the following modes listed in Table 2: Default CodeLoader Modes for LMK03806
may be restored by clicking “Mode” and selecting the appropriate device configuration, as shown in
Figure 2 in the case of the LMK03806B device. Similar default modes are available for each
LMK03806B device in CodeLoader.
Figure 2: Selecting a Default Mode for the LMK03806B Device
After restoring a default mode, press Ctrl+L to program the device. The default modes also disable
certain outputs, so make sure to enable the output under test to make measurements.
Table 2: Default CodeLoader Modes for LMK03806
Default CodeLoader Mode
XO
Frequency
LMK03806B, 100 MHz 100 MHz
The next section outlines step-by-step procedures for using the evaluation board with the LMK03806B.