Datasheet

42 SNAU075A LMK3806 Evaluation Board November 2013

The Adapter Board

This table describes the pins configuration on the adapter board for each EVM board (See examples below table)

EVM

Jumper Bank Code Loader Configuration

A B C D E F G H

LMX2581 A4 B1 C2 E5 F1 G1 H1 BUFEN (pin 1), Trigger (pin 7)

LMX2541 A4 C3 E4 F1 G1 H1 CE (pin 1), Trigger (pin 10)

LMK0400x A0 C3 E5 F1 G1 H1 GOE (pin 7)

LMK01000 A0 C1 E5 F1 G1 H1 GOE (pin 7)

LMK030xx A0 C1 E5 F1 G1 H1 SYNC (pin 7)

LMK02000 A0 C1 E5 F1 G1 H1 SYNC (pin 7)

LMK0480x A0 B2 C3 E5 F0 G0 H1 Status_CLKin1 (pin 3)

LMK04816/4906 A0 B2 C3 E5 F0 G0 H1 Status_CLKin1 (pin 3)

LMK01801 A0 B4 C5 E2 F0 G0 H1 Test (pin 3), SYNC0 (pin 10)

LMK0482x (prelease) A0 B5 C3 D2 E4 F0 G0 H1 CLKin1_SEL (pin 6), Reset (pin 10)

LMX2531 A0 E5 F2 G1 H2 Trigger (pin 1)

LMX2485/7 A0 C1 E5 F2 G1 H0 ENOSC (pin 7), CE (pin 10)

LMK03200 A0 E5 F0 G0 H1 SYNC (pin 7)

LMK03806 A0 C1 E5 F0 G0 H1

LMK04100 A0 C1 E5 F1 G1 H1

Example adapter configuration (LMK01801)

Open Codeloader.exe  Click “Select Device”  Click “Port Setup” Tab  Click “USB” (in Communication Mode)

*Remember to also make modifications in “Pin Configuration” Section according to Table above.