Datasheet

SNAU118
LMK01801BEVAL Evaluation Board Operating Instructions
7
Quick Start – Pin Control Mode
1. Connect a voltage of 3.3 volts to either the Vcc SMA connector or the alternate connector.
2. Connect a reference clock from a signal generator or other source. Exact frequency
depends on programming.
3. Install a jumper on EN_PIN_CTRL header in either the High or Low position.
4. Install other jumpers on Type0, Type1, Type2, DivVal0, DivVal1, and DivVal2 headers
based on the configurations shown in Table 1 and Table 2.
Figure 3 - Pin Control Mode Quick Start Diagram