Datasheet

SNAU118
LMK01801BEVAL Evaluation Board Operating Instructions
17
Bits/Pins Tab
Figure 11 - Bits/Pins tab.
The Bits/Pins tab allows the user to program bits directly. Many of which are not available on
other tabs. Refer to the datasheet for more detailed information. The bits available are:
 Common Box
o RESET - Set the reset bit. This will reset the device. In a normal application it is
not necessary to program this bit clear since it is auto-clearing. However in the
CodeLoader software, RESET must be clicked again (cleared) to not cause a reset
every time R7 is programmed.
o POWERDOWN - Place the device in powerdown mode.
 Program Pins Box – These pins only have effect if the PWB headers are in the uWire
position (3-5). See Figure 2 - Quick Start Diagram for the correct configuration.
o EN_PIN_CTRL – Sets the control of the output via uWire or pins
o SYNC0 – Set high or low voltage on SYNC0 pin. Checked is high voltage.
o TRIGGER – Set high or low voltage on pin 10 of uWire header.