Datasheet

SNAU118
LMK01801BEVAL Evaluation Board Operating Instructions
13
Connector Name Input/Output Description
CLKin0/CLKin0*,
CLKin1/CLKin1*
Input
Populated connectors.
The default board configuration is setup for a single-ended
reference source at CLKin0* (CLKin0 pin is AC-coupled
to ground).
If a DC-coupled clock is used to drive either of the inputs,
the high voltage level must be at least 2 volts and the low
voltage no greater than 0.4 volts.
uWire Input/Output
Populated connector.
10-pin header programming interface for the board. Of
Most important are the CLKuWire, DATAuWire, and
LEuWire programming lines from this header. Each of
these signals, TEST, and SYNC0, and SYNC1 can be
monitored through test points on the board.
SYNC0,
SYNC1
Input
Unpopulated connector.
Access to SYNC0 or SYNC1 of device.